Contents
- Index
- Previous
- Next
The "Measure Point/Statistics" window
This window shows you details about the selected measure point in the data grid of the main screen!
Measure points (Previous/Selected/Next)
This section shows you the number and the absolute date/time of the selected, the previous and next measure point! Between the measure points the relative time in days and time is displayed between the measure points, so you can quickly view the delta time values of the three measure points.
Data bytes
If the selected measure point contains data from the D1/Tx or D2/Rx data line, it is displayed here. The characters are shown in either USASCII or EBCDIC, as selected in the display mode settings and in hexadecimal, decimal, octal and binary at the same time. So you don't have to switch to take a quick look.
Data Counter/Signal lines
Below the data bytes, the data counters and all signal lines get displayed with its description, the status "High" or "Low" and the assigned pin of the RS232 interface!
Line Load/Quality Gauges and Error Statistics
The last section shows you colored gauges for the line load actual (how much traffic the line has now), the line load peek (the highest traffic of the complete recording session) and the line quality (only green at 100% quality level).
At the right side you can find information about how many parity, framing or line errors occurred in the record file (session).
If you cannot see the window, use the menu "Window | Measure Point/Statistics" to get it. If it must be visible in theory though clicking this function more than once, it may be, that you changed the resolution of your PC's graphics card or another event occurred, that positioned the window out-of-screen!
Therefore you can reset it to a visible layout on your monitor by using the function "Reset all windows"!
ComTrace Help Contents